Skip to content
Call (719) 963-7440
Silver StagExteriors

Security-Widefield, CO · El Paso County

Wood Siding & Trim Painting in Security-Widefield

The short answer

Wood Siding & Trim Painting in Security-Widefield, CO: Scraping, rot replacement and priming on real wood, done to a standard that survives the freeze-thaw cycle here.

What it costs
Wood costs more than stucco or fiber cement to paint, and the variable is rot rather than square footage. We quote the painting and the carpentry as separate lines, because you should be able to see how much of the number is boards.
What is included
Scraping to sound substrate and feathering the edges; Replacing rotted siding boards, trim and sills rather than filling them; Priming replacement material on all six faces, including cut ends, before it goes up; Sealing end grain, which is where water enters wood first; Caulking at joints and transitions, left open where the assembly needs to drain; Two finish coats on bare or repaired substrate.
Where we work
Security-Widefield and the surrounding El Paso County, including Security, Widefield, Stratmoor.
Getting a quote
Free and no obligation. Call (719) 963-7440 or request a quote online.

Painting wood is different from painting stucco or fiber cement because wood moves, absorbs water, and rots. On the older housing stock through Old Colorado City, Manitou and the established west side, an honest exterior quote is part painting and part carpentry, and the carpentry is the part that decides how long the paint lasts.

What this means in Security-Widefield specifically

Siding and paint substrates here

Original painted wood, hardboard and masonite siding at an age where sections have failed outright. Masonite in particular swells and delaminates once the coating fails, and no amount of paint reverses it.

Wind exposure

Strong downslope winds off the front range, on older roofs with older fastening standards. Wind uplift on roofs installed to 1970s and 1980s practice is a materially different risk than on a modern install.

Snow load and ice damming

Around 5,600 feet with fast melt cycles. Freeze-thaw at the eave is the main mechanism rather than sustained load, and older homes with thin attic insulation dam ice more readily.

Where the water has to go

Older subdivision grading with the house frequently sitting close to level with the surrounding ground, which leaves little margin for water discharged near the foundation. Fountain Creek runs through the area and the water table is higher here than in most of the county, so basement moisture complaints are more common and roof drainage is worth eliminating as a cause first.

Security-Widefield sits at approximately 5,600 feet.

What is included

  • Scraping to sound substrate and feathering the edges
  • Replacing rotted siding boards, trim and sills rather than filling them
  • Priming replacement material on all six faces, including cut ends, before it goes up
  • Sealing end grain, which is where water enters wood first
  • Caulking at joints and transitions, left open where the assembly needs to drain
  • Two finish coats on bare or repaired substrate

How we do it

  1. 1

    Find the water first

    Rot is downstream of something. An overflowing gutter, a missing drip edge, a failed caulk joint. We identify it before painting, because otherwise you are repainting the same board in three years.

  2. 2

    Scrape and cut out

    Failed coating removed to a sound edge. Rot cut back past where it is visible, because it travels along the grain further than the stain suggests.

  3. 3

    Prime everything, including the parts nobody sees

    New boards primed on all six faces before installation. Back-priming is invisible, adds real time, and is most of the difference between a ten year job and a four year one.

  4. 4

    Caulk with judgment

    Not every gap should be sealed. Some are drainage paths, and caulking them traps water inside the wall. Knowing which is which is the skill.

What it costs

Wood costs more than stucco or fiber cement to paint, and the variable is rot rather than square footage. We quote the painting and the carpentry as separate lines, because you should be able to see how much of the number is boards.

We quote Security-Widefield properties before starting, and the number you hear is the number you pay. If something on site changes the scope, you hear about it before we do the work rather than on the invoice.

Neighborhoods we serve in Security-Widefield

Security, Widefield, Stratmoor, and everywhere else in Security-Widefield.

Fully Insured
Free Photo-Documented Inspection
Written Scope Before You Sign
Locally Owned & Operated

Wood Siding questions from Security-Widefield

Should I replace the rotted boards or fill them?

Replace, in almost every case. Epoxy filler is legitimate for small localized damage in something you cannot easily replace, like a decorative element. Used on a rotted siding board it is a cosmetic answer to a moisture problem and it fails from behind, where you cannot see it coming.

Is lead paint a concern on my house?

If it was built before 1978, assume yes until tested. That changes how the surface can legally and safely be prepared — containment, HEPA cleanup, and disposal requirements. It is a real cost difference and any contractor who does not raise it on a pre-1978 house is either unaware or ignoring it.

How long should paint last on wood siding here?

Seven to ten years with proper preparation, less on south and west elevations. Our freeze-thaw cycling is hard on coatings — the substrate expands and contracts through a wide daily temperature swing, and a coating with poor adhesion is worked loose faster than it would be in a milder climate.

Can you spray it instead of brushing?

Spraying lays a more uniform film and is faster. On weathered wood, back-brushing after spraying works the coating into the grain and adheres substantially better. Spraying alone on a rough substrate looks right and bonds poorly.

Wood Siding & Trim Painting in Security-Widefield

Free quote, an honest answer about what is achievable, and no pressure either way.