Colorado Springs, CO · El Paso County

Fascia & Soffit Repair in Colorado Springs

The short answer

Fascia & Soffit Repair in Colorado Springs, CO: Repair or replacement of the boards behind and beneath your gutters, plus the water problem that rotted them in the first place.

What it costs: Fascia replacement is priced per linear foot and depends heavily on height, board dimension and how much gutter has to come down. Isolated sections are a modest job. A full perimeter replacement on a two-story house is a substantial one, and worth pairing with gutter replacement if the gutters are aging.
What is included: Removal and replacement of rotted fascia board; Soffit repair, including panels damaged by ice or animals; Drip edge or gutter apron fitted so water cannot wick behind the fascia; Correcting the drainage fault that caused the rot; Restoring soffit vent airflow where repairs or insulation have blocked it; Priming and painting, or wrapping in aluminum coil.
Where we work: Colorado Springs and the surrounding El Paso County, including Briargate, Rockrimmon, Old Colorado City.
Getting a quote: Free and no obligation. Call (719) 963-7440 or request a quote online.

Fascia is the board your gutters hang from, and soffit is the underside of the overhang. They fail from water, and the water is almost always coming from a gutter that overflowed, a missing drip edge, or a downspout joint that has been dripping down the wall for two years. Replacing the board without finding that is a repair with an expiry date.

What this means in Colorado Springs specifically

What ends up in the gutters here

Two different problems depending on where you are. The mature cover through Old Colorado City, the Broadmoor and Cheyenne Canon drops a heavy seasonal leaf load that fills gutters within weeks in October. East-side subdivisions across Briargate and Powers have young landscaping and see far more grit than organic matter, which packs into a fine sludge at the bottom of the trough rather than blocking it outright.

Where the water has to go

The city grades steeply off the foothills, so lots on the west side frequently fall toward the house or across a neighboring property, and a four foot downspout extension does nothing on that kind of slope. Expansive clay soils are widespread here, and they swell when they get wet against a foundation. Getting roof water genuinely away from the house matters more in this soil than it would in sand.

Siding and paint substrates here

Wide substrate range. Pre-war west-side homes are painted wood siding and trim that need real scraping and priming. Briargate and Powers construction is mostly stucco and fiber cement with painted trim, where the failure point is caulk joints and south-facing elevations rather than the field.

Snow load and ice damming

The Springs itself sits below the heaviest snow band. Storms tend to come wet and heavy in March, then melt within days, so sustained load is less of a concern than the freeze-thaw cycling that works at flashing and shingle edges. Ice damming shows up mostly on north-facing eaves over poorly insulated attics.

Colorado Springs sits at approximately 6,035 feet.

What is included

Removal and replacement of rotted fascia board
Soffit repair, including panels damaged by ice or animals
Drip edge or gutter apron fitted so water cannot wick behind the fascia
Correcting the drainage fault that caused the rot
Restoring soffit vent airflow where repairs or insulation have blocked it
Priming and painting, or wrapping in aluminum coil

How we do it

1
Find the water first
Rot is evidence. We work out where the water was coming from before pricing the carpentry, because otherwise you will be paying for the same board again.
2
Take out everything soft
Rot travels along the grain past where it is visible. We cut back to sound wood, which sometimes means a longer section than the stain suggests.
3
Rebuild and detail properly
New board, primed on all six faces before it goes up including the cut ends, then drip edge so the water that caused the problem cannot repeat it.
4
Re-hang the gutter correctly
The run goes back on hidden hangers at proper pitch, not back onto the old spike holes.

What it costs

Fascia replacement is priced per linear foot and depends heavily on height, board dimension and how much gutter has to come down. Isolated sections are a modest job. A full perimeter replacement on a two-story house is a substantial one, and worth pairing with gutter replacement if the gutters are aging.

We quote Colorado Springs properties before starting, and the number you hear is the number you pay. If something on site changes the scope, you hear about it before we do the work rather than on the invoice.

Neighborhoods we serve in Colorado Springs

Briargate, Rockrimmon, Old Colorado City, Broadmoor, Powers, Stetson Hills, Cheyenne Cañon, and everywhere else in Colorado Springs.

Fully Insured

Free Photo-Documented Inspection

Written Scope Before You Sign

Locally Owned & Operated

Fascia & Soffit questions from Colorado Springs

Can you replace fascia without removing the gutters?

No, and anyone who says yes is not replacing the fascia. The gutter hangs on it. Removal and re-hang is part of the job, which is why it is worth combining fascia work with gutter replacement if both are near the end of their life.

Should I wrap fascia in aluminum?

Coil wrap protects the board and removes repainting from your maintenance list. It also hides the board, which means the next round of rot is invisible until it is severe. On a well-detailed roof with a working gutter it is a reasonable choice. On a house with a history of overflow, fix the drainage first or you are wrapping a problem.

Why do birds and squirrels keep getting into my soffit?

Because there is a gap, usually at a corner or where the soffit meets the fascia, and often opened by earlier water damage. Sealing it without checking for an active nest is both cruel and a mistake, since anything trapped inside dies in the cavity. We check first.

Is soffit venting worth restoring?

Yes, and it is one of the most commonly wrecked details on older houses. Blown attic insulation pushed out over the top plate blocks intake vents constantly. Without intake, ridge vents cannot work, and the attic runs hot in summer and damp in winter. It is also directly implicated in ice damming.

Related work in Colorado Springs

Often booked together

Fascia & Soffit in nearby communities

All gutters in Colorado Springs →Everything we do in Colorado Springs →