Woodland Park, CO · Teller County

Log & Cedar Home Staining in Woodland Park

The short answer

Log & Cedar Home Staining in Woodland Park, CO: Stripping or blasting, borate treatment, chinking inspection and a stain system built for the UV load above 7,000 feet.

What it costs: Log work is priced per building after inspection, because stripping method and chinking condition drive it far more than size does. Maintenance coats on a sound finish cost a fraction of a full strip and re-stain, which is the argument for staying ahead of the cycle rather than waiting for visible failure.
What is included: Media blasting or chemical stripping of failed finish; Borate treatment against rot and wood-boring insects before coating; Chinking and caulk joint inspection, with failed sections cut out and replaced; Log-specific stain systems, applied in the coats the system actually specifies; Clear topcoat where the system calls for it; Elevation-by-elevation assessment so the schedule matches the exposure.
Where we work: Woodland Park and the surrounding Teller County, including Sunnywood, Tranquil Acres, Paradise Estates.
Getting a quote: Free and no obligation. Call (719) 963-7440 or request a quote online.

A log home is a maintenance commitment rather than a finish, and homeowners who move up from the Springs are frequently surprised by how much faster coatings fail at 8,000 feet. South and west elevations on a log home in Woodland Park can need attention in half the time the north side does, and treating the whole building on one schedule wastes money on one side and neglects the other.

What this means in Woodland Park specifically

Siding and paint substrates here

Heavy use of stained wood, cedar and log construction. Extreme UV at this elevation destroys coatings on south and west elevations far faster than most homeowners expect, and stain maintenance intervals here are roughly half what they are at 6,000 feet.

Snow load and ice damming

At 8,465 feet this is the heaviest snow load in our service area by a wide margin. Sustained load, ice damming and meltwater intrusion are the defining roofing problems. Ventilation, eave membrane coverage well past the wall line, and proper snow retention on metal roofs are not upgrades here, they are the job.

Wind exposure

Exposed ridgelines and mountain terrain produce strong, gusty wind with rapid direction changes. Combined with heavy snow, uplift and wind-driven snow intrusion under courses are both real.

What ends up in the gutters here

Dense pine cover dropping needles and pitch year round, which makes this the one part of our service area where micro-mesh guards are genuinely worth their price. Coarse screens are functionally useless against ponderosa needles, and a great many houses here have them fitted anyway. Pitch also binds needles onto the mesh surface, so even a correct guard needs clearing from above occasionally.

Woodland Park sits at approximately 8,465 feet.

What is included

Media blasting or chemical stripping of failed finish
Borate treatment against rot and wood-boring insects before coating
Chinking and caulk joint inspection, with failed sections cut out and replaced
Log-specific stain systems, applied in the coats the system actually specifies
Clear topcoat where the system calls for it
Elevation-by-elevation assessment so the schedule matches the exposure

How we do it

1
Assess each elevation separately
South and west take the UV and fail first. North and east often have years left. A single answer for the whole building is nearly always wrong on a log home.
2
Strip back to sound wood
Media blasting is the usual method and it is as much about the operator as the equipment — too aggressive and you raise the grain and damage the surface, too gentle and old finish stays behind and the new coat fails over it.
3
Treat before coating
Borate treatment goes on bare wood and protects against rot and boring insects from inside the log. It has to be done before any finish, and it cannot be added later without stripping again.
4
Check the chinking
Failed chinking lets water into the log, and no stain compensates for that. This is inspected and repaired as part of the job rather than quoted as a surprise.

What it costs

Log work is priced per building after inspection, because stripping method and chinking condition drive it far more than size does. Maintenance coats on a sound finish cost a fraction of a full strip and re-stain, which is the argument for staying ahead of the cycle rather than waiting for visible failure.

We quote Woodland Park properties before starting, and the number you hear is the number you pay. If something on site changes the scope, you hear about it before we do the work rather than on the invoice.

Neighborhoods we serve in Woodland Park

Sunnywood, Tranquil Acres, Paradise Estates, and everywhere else in Woodland Park.

Fully Insured

Free Photo-Documented Inspection

Written Scope Before You Sign

Locally Owned & Operated

Log & Cedar questions from Woodland Park

How often does a log home need re-staining at elevation?

Commonly 3 to 5 years on south and west elevations and 5 to 8 on north and east, which is roughly half the interval you would expect at lower altitude. UV is the dominant factor and it is meaningfully more intense at 8,000 feet than at 6,000.

Is media blasting safe for the logs?

In competent hands, yes, and it is usually the best method. It is also easy to do damage with, raising the grain or eroding softwood. Ask what media they use and ask to see a test patch on an inconspicuous elevation before they do the whole building.

What is borate treatment and do I need it?

A mineral salt that penetrates the wood and makes it unpalatable to rot fungi and boring insects. On bare logs it is cheap insurance and the window for applying it is only open while the wood is stripped. If you are already paying to strip a log home, skipping it is a false economy.

Can you just recoat over the existing finish?

If the existing finish is sound, compatible and the same system, a maintenance coat is legitimate and much cheaper. That is the ideal maintenance cycle. Once a finish has actually failed, recoating over it fails with it, and the strip is unavoidable.

Related work in Woodland Park

Often booked together

Log & Cedar in nearby communities

All painting in Woodland Park →Everything we do in Woodland Park →